Pitney-bowes DI425 FastPac Inserting Systems Manuel d'utilisateur télécharger pdf (Page 18)

2 • Operation

2-2 SV61656 Rev. A

Select a Job

When the machine is turned ON,

the display shows the last job run

and “Trial Piece Required”.

Press the Job button until the job

you require is displayed, or press

Default if you want to run the

machine with your standard job

settings.

Note: Only a Pitney Bowes Service Representative can modify the

default job.

If you have material loaded, press

Trial Piece. The machine sets

itself and runs a test piece for you

to check.

If you don’t have material loaded,

do this now, then return to this

section. Loading feeders and re-

lated instructions are covered on pages 2-4 to 2-7.

Note:

You may have selected a manual feed job where sheet feeder 1 is

set for manual feed of collated sets. If this is the case, DO NOT load

the sheet feeder; you will feed collated sets one at a time by hand as

required by the machine.

For manual feed jobs, pull back

the lever as shown in the illustra-

tion, right. This opens the feed

mechanism, making it ready for

manual feed operation.

Remember to return this lever to

its normal position when you use

the feeder for automatic opera-

tion.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

Pas de commentaire

Pitney-bowes DI425 FastPac Inserting Systems Manuel d'utilisateur Page 18